YesBes Split Wire Loom Tubing 1/4", 3/8", 1/2" x 50ft Kit

YesBes Split Wire Loom Tubing is a flexible, split polyethylene conduit kit (three diameters, 50 ft each) designed to neatly protect and organize electrical cables in automotive, marine, office, and home applications.

Keep wiring tidy, shielded from abrasion, and easier to route. This kit includes three commonly used inner diameters — 1/4", 3/8", and 1/2" — each supplied on a 50-foot roll in black. The pre-slit design lets you insert existing wires without disconnecting connectors, while the resilient polyethylene resists wear, flexing, and a wide range of temperatures.

How do I install the split wire loom without rewiring?

Installation is straightforward because the tubing is factory-slit along its length. Just measure and cut the desired length, open the slit, lay the cable bundle inside, and let the slit close around the wires — no splicing or disconnecting required.

• Measure and trim with ordinary scissors or a utility knife.
• Open the slit, insert cables, and let the slit seal around them.
• Use zip ties, adhesive clips, or clamps to secure runs and prevent movement.
• Mix and match the three diameters to suit different cable bundles.

Which diameters suit my project and how do I choose?

Choose a diameter by comparing your cable bundle thickness to the tubing inner diameter. Small power or signal leads fit the 1/4" size, medium bundles or single automotive lines fit 3/8", and multiple conductors or thicker cords use 1/2". Because this kit contains all three sizes, you can test and use the exact fit for each location.

• 1/4" — thin wires, sensor leads, signal cables.
• 3/8" — medium bundles, audio/video cords, light harnesses.
• 1/2" — thicker cables, multiple wires, power leads.
• Keep slack for bends and connectors; don’t overfill a tube.

Will this tubing stand up to heat, moisture, and rough use?

The polyethylene construction tolerates a wide temperature range and protects against abrasion and light exposure. It is suitable for interior engine bay locations away from direct exhaust surfaces, and it helps reduce chafing and wear on cables used outdoors or in damp spaces.

• Operating range roughly -40°F to 200°F for typical applications.
• Resists rubbing, creasing, and mild chemical splash exposure.
• Not recommended for direct contact with very hot manifolds or flames.
• Black finish reduces visible dirt and blends with wiring harnesses.

How do I maintain and secure the wire loom once installed?

Maintenance is minimal: inspect for cuts or severe abrasion and replace damaged sections. Use common fastening hardware to anchor runs and reduce movement, and trim ends cleanly for a professional look. If routing near sharp edges, add grommets or wrap with additional protection at the contact point.

• Anchor every few feet with zip ties or clipped mounts.
• Trim ends squarely; use heat-shrink or tape for neat terminations.
• Replace any section showing deep cuts or exposed wires.
• Add rubber grommets where wires pass through metal panels.

Who is this for: DIYers, mechanics, boat owners, office managers, AV installers, and homeowners who want an affordable, flexible way to protect, organize, and extend the life of cable runs. The YesBes split wire loom kit is especially useful if you need multiple diameters on hand for varied projects — from tidying desk cables to bundling automotive harnesses — without permanent reconfiguration of connectors or terminals.