tekit C14 to C7 Power Cable 2m 10A IEC Figure-8

Tekit’s molded IEC 320 C14 to C7 power cable is a 2-meter, 10A-rated AC lead designed to connect PDUs, UPS units, and compatible electronics with a reliable, PVC-jacketed build.

This heavy-duty molded power cord bridges IEC 320 C14 (male) outlets to figure-8 IEC C7 devices, offering a dependable, standardized cable for server racks, desktop power distribution units, uninterruptible power supplies, and consumer electronics. Constructed with a molded design and durable PVC insulation, it minimizes stray strain at the connector ends while delivering up to 10 amps across 110–240 volts. The 2.0 m (6.6 ft) length provides flexible placement without excess slack, and the 18 AWG (2 x 0.75 mm²) conductors balance durability with manageable thickness for most equipment racks and home setups.

What devices will this Tekit C14 to C7 cable power?

This cord connects equipment that accepts an IEC C7 (figure-8) inlet to a C14 outlet commonly found on PDUs, UPSs, and some power supplies. It is appropriate where the device requires a non-grounded two-pin connection and the source provides a standard IEC C14 output.

• Small AV gear and set-top boxes with C7 inlets
• Some laptop power bricks, portable radios, and game consoles using figure-8 connectors
• Power distribution units and uninterruptible power supplies with C14 sockets

How durable and safe is the cable for continuous use?

The Tekit cable uses a molded connector design and PVC insulation that resists abrasion and reduces connector strain, making it suitable for repeated plugging and unplugging. With a 10A/110–240V rating and 18 AWG conductors, it meets common power requirements for the types of devices listed, though users should always check device amperage requirements.

• Molded housing prevents loose pins and reduces entry of dust
• PVC jacket offers chemical and wear resistance in typical environments
• 18 AWG (2 x 0.75 mm²) wiring balances flexibility and current capacity

Will this cable work with my UPS or PDU in a server rack?

Yes — when your PDU or UPS has an IEC C14 output and the target device accepts an IEC C7 inlet, this cable provides a direct, plug-and-play connection. Its 2-meter length gives room to route between rack-mounted outlets and equipment without tight bends.

• Compatible with standard C14 outlets on PDUs and UPS devices
• 2.0 m length eases cable routing in racks and cabinet setups
• Molded ends reduce strain in high-traffic rack environments

Who is this for: Technicians, AV installers, IT administrators, and home users who need a simple, reliable connection from standard IEC C14 power sources to equipment using the figure-8 C7 inlet. If you manage small servers, media players, console devices, or peripheral equipment that draws less than 10 amps and uses a non-grounded C7 plug, this Tekit molded cable is a practical, low-cost solution to keep gear powered and neatly routed.