MOOKEERF RG8X 100ft Coax Cable PL259 Male-to-Male

MOOKEERF RG8X 100ft is a low-loss, 50-ohm coaxial cable assembly with PL259 male-to-male connectors designed for CB, ham radio and antenna test equipment.

This RG8X coaxial cable by MOOKEERF pairs a solid copper inner conductor with double shielding and a durable PVC jacket to minimize signal loss and resist outdoor wear. The assembled 100-foot length and upgraded 2.2" heat-shrink protector at each PL259 connector are intended to give clearer RF transmission, reliable mechanical strain relief, and broad compatibility with 50-ohm systems like CB radios, ham setups, SWR meters, antenna analyzers and dummy loads.

How does this cable reduce signal loss over long runs?

The RG8X construction uses a solid copper core and a dual-layer shield (aluminum foil plus tinned copper braid) to lower attenuation and block external interference. That combination keeps more signal energy on the center conductor across VHF/UHF frequencies.

• Solid copper inner conductor for stable conductivity
• Aluminum foil + tinned-copper braid double shielding
• 50-ohm impedance suitable for common RF test and antenna gear
• PVC jacket to limit moisture and environmental degradation

Are the PL259 connectors robust enough for field and outdoor use?

MOOKEERF installs male PL259 connectors and extends the heat-shrink protector to 2.2" at each junction to better guard against connector strain and separation. The added sleeve helps keep the termination intact during repeated hookups and outdoor deployments.

• PL259 male-to-male terminations for broad compatibility
• Extended 2.2" heat-shrink for stronger mechanical support
• Proper crimping/solder joints reduce intermittent connections
• Durable outer jacket for abrasion and weather resistance

Which devices and applications is this RG8X cable suited for?

This 100ft 50-ohm assembly works with most CB and ham radio antennas, VHF marine equipment, antenna analyzers, SWR meters, dummy loads and tuners. It’s designed as a general-purpose RF link where moderate-length runs and reasonable flexibility are required.

• CB radios and mobile base antenna connections
• Ham radio transceivers and VHF/UHF antennas
• Antenna analyzers, SWR meters, dummy loads, and tuners
• Temporary field setups or semi-permanent antenna installations

What should I expect in terms of durability and maintenance?

The cable’s PVC jacket and tinned-braid shielding provide corrosion resistance and a measure of UV/abrasion protection for outdoor use. Occasional inspection of the connectors and protective sleeve is recommended, and resealing or replacing damaged sections keeps performance steady.

• PVC jacket resists weathering and physical wear
• Tinned braid reduces oxidation on the outer conductor
• Check heat-shrink sleeves and connector tightness periodically
• Replace cable if inner conductor or shielding is visibly compromised

Who this is for: This MOOKEERF RG8X 100ft cable is intended for radio hobbyists, mobile/vehicle CB users, marine VHF operators, field technicians and anyone needing a long, flexible 50-ohm link between transceivers, antenna analyzers and test gear. It suits users who want a balance of low loss, mechanical protection at the connectors, and a length adequate for most mast-to-shack or temporary field runs without needing heavier, less-flexible coax types.