THE CIMPLE CO RG6 Coaxial Cable 100 FT Dual-Shielded

THE CIMPLE CO RG6 100 FT is a dual-shielded, watertight coaxial cable built for reliable indoor and outdoor connections to satellite, cable, and antenna equipment.

This 100-foot RG6 cable combines a low-loss 18 AWG solid center conductor, aluminum braid shielding, and weather-stable connectors to carry analog and digital signals with minimal interference. Designed for runs that cross indoor living spaces and exterior lines, it arrives with UV-resistant PVC jacket and rubber weather boots to protect connections from moisture and sun damage. Whether you’re connecting a satellite receiver, cable modem, HDTV antenna, or CATV equipment, this cable is engineered to maintain signal integrity across long distances and higher frequencies.

How does this cable preserve signal quality over long runs?

The cable uses a solid 18 AWG center conductor and multi-layer aluminum braiding to reduce attenuation and block electromagnetic interference. It’s swept to 3.0 GHz, so high-frequency digital signals travel with minimal loss, and analog signals remain clear.

• 18 AWG solid center conductor for stable signal transfer
• Aluminum braid and foil shielding to reduce noise and interference
• Rated 75 ohm and tested up to 3.0 GHz for broad compatibility
• Low-loss design suited for longer cable runs

Can I use this cable outdoors and expect it to last?

Yes — the cable and connectors are made for outdoor exposure with UV-resistant jacketing and weather-sealed fittings. The rubber boots and double O-ring compression connectors provide a watertight barrier at connection points to help prevent corrosion and moisture ingress.

• UV-coated PVC outer jacket resists sun-related degradation
• Weather-booted ends with double O-ring compression seals
• Precision-machined connectors fit snugly to prevent loosening
• Suitable for rooftop, satellite dish, and external antenna installs

What devices and systems is this RG6 cable compatible with?

This 75-ohm RG6 cable supports a wide range of home and commercial AV and data applications, including both digital and analog systems. It works with cable and satellite receivers, modems, HDTV and OTA antennas, and most CATV installations without adapters.

• Cable modems and internet gateway devices
• Satellite receivers and set-top boxes
• HDTV antennas, off-air/OTA and free-to-air antennas
• CATV systems, radio gear, and many coaxial accessories

How easy is installation and what hardware comes with the cable?

The cable is pre-terminated with weather-stabilized F-type connectors and rubber boots, so typical installs only need a wrench to tighten connectors. For wall penetrations or outdoor mounts you may need basic mounting hardware and sealant, but the cable itself is prepared for direct connection to most receivers and modems.

• Pre-attached weather-compression F-type connectors
• Rubber weather boots included for each end
• Works with standard F-type ports—no special adapters required
• Cuttable and re-terminable if custom lengths are needed

Who is this for? Installers, homeowners, and AV enthusiasts who need a dependable, weatherproof coax run between 30 meters (100 feet) of equipment and external antennas or service entry points will find this cable a practical solution. It’s suited for anyone who values clear, interference-resistant signal transmission for TV, satellite, internet, and CATV across indoor and outdoor environments.