T-H Marine G-Force Troll Jacket 60" Neoprene Cable Sleeve

The T-H Marine G‑Force Troll Jacket is a 60" long, 2 mm neoprene sleeve that neatly bundles and protects trolling motor and accessory cables with a hook-and-loop closure for easy install and service.

Designed for anglers and boat owners who want a cleaner, safer bow area, the G‑Force Troll Jacket wraps multiple wires into a single protected jacket that reduces abrasion, UV exposure, and deck snags. Its cut-to-fit length and hook-and-loop fastener let you install without disconnecting connectors, and you can trim side slots to route cables exactly where you need them.

How does the sleeve protect my trolling motor and accessory wires?

The 2 mm neoprene construction cushions cables against chafing and exposure to sunlight, while the enclosed wrap reduces the chance of lines catching on deck hardware. Neoprene also resists moisture and helps keep wires from rubbing against rough surfaces.

• 2 mm heavy-duty neoprene reduces abrasion from deck edges and fasteners
• Shields wires from UV damage that can degrade insulation
• Encases multiple leads to prevent individual wire wear

Can I customize the Troll Jacket to fit my setup?

Yes — the 60" length is intended to be trimmed and modified so your cables can exit where needed. The wrap design allows you to cut side slots at any position without compromising the jacket’s performance, making it compatible with many bow-mount layouts.

• 60" cut-to-fit length for custom routing and neat runs
• Side slots can be trimmed to route power, sonar, and accessory leads
• Install around existing wiring without unplugging connectors

Will this fit my Minn Kota or MotorGuide bow-mount system?

The Troll Jacket is sized to accommodate most Minn Kota and MotorGuide bow-mount wiring runs by bundling wires into a roughly 1.5" diameter jacket while leaving room for additional leads like transducer and HydroWave cables. It is not intended for models with coiled power cords such as Terrova-style coils.

• Approximately 1.5" wrapped diameter for common bow-mount wiring bundles
• Compatible with many factory and aftermarket lead arrangements
• Designed to avoid interference with coiled-cord motor models

How easy is installation and maintenance?

The full-length hook-and-loop closure installs in seconds and can be reapplied for service access without cutting or zip ties. Because you don’t have to disconnect each cable, routine checks and accessory swaps are faster.

• Hook & loop fastening for tool-free installation and removal
• Wraps around cables without unplugging connectors
• Removes the need for zip ties and tape that can trap moisture

Who is this for: The T-H Marine G‑Force Troll Jacket is built for recreational and tournament anglers, deck hands, and DIY boat owners who want a tidier, better-protected bow area. It’s ideal if you use a bow-mounted electric motor plus accessories (sonar, HydroWave, GPS), want a solution that’s quick to install and service, and prefer a material that resists abrasion and UV effects. If your motor uses a coiled power cord, confirm compatibility before trimming.