Sky High Car Audio 1/0 Ga CCA Amp Kit with Twisted RCA

Sky High Car Audio's Oversized 1/0 Ga CCA Amp Kit is a complete amplifier wiring package with pre-terminated 1/0 gauge power and ground, twisted RCA signal cables, ANL fuse protection, and installation accessories for high-current car audio builds.

If you're wiring a powerful mobile audio system and need a single kit that covers power, ground, signal, protection, and tidy finishes, this set is built to simplify the job. The kit combines oversized copper-clad aluminum (CCA) power conductors with pre-attached copper lugs and heat-shrink, twisted two-channel RCA leads, a remote turn-on wire, and a heavy-duty ANL fuse holder so you can install faster and more cleanly.

How does the 1/0 gauge CCA power wire improve my amplifier setup?

The oversized 1/0 gauge increases current-carrying capacity compared to smaller wires, lowering voltage drop under heavy loads. Using copper-clad aluminum keeps the cable more affordable while improving conductivity over pure aluminum, and the included copper lugs ensure secure connections to battery and amplifier terminals.

• 1/0 gauge size for high-current demands
• CCA construction balances cost and conductivity
• Pre-terminated 3/8" copper lugs for reliable termination
• Heat-shrink sleeves included for insulated, neat terminations

Will the signal cables and remote wire keep audio clear and stable?

Twisted-pair RCA cables reduce electromagnetic interference and help preserve a cleaner low-level signal between head unit and amp. The kit also provides a dedicated blue remote wire so your amplifier powers on and off reliably with the radio, avoiding accidental battery drain.

• 18 ft twisted 2-channel RCA for stereo signal runs
• 17 ft blue remote wire sized for standard turn-on circuits
• Twist construction minimizes noise pickup in tight engine bays
• Length choices cover common head unit-to-amp routing paths

What protection and installation aids come in the kit?

The included ANL fuse holder and fuse sit close to the battery to guard wiring against shorts and overloads. For quick, secure installs the power and ground leads are pre-crimped with closed-end copper lugs, and shrink tubing is supplied to seal those connections. The kit also bundles cable ties and a grommet for a finished, vehicle-friendly routing.

• ANL fuse holder with fuse for battery-side protection
• Pre-installed closed-end copper lugs (3/8" diameter) for secure terminals
• SHCA heat-shrink tubing for insulated lug coverage
• Zip ties and grommet included for neat, safe routing

How does this kit save time during installation?

Having power, ground, remote, signal cables, fuse protection, and mounting accessories in one package eliminates parts hunting and reduces prep work. Pre-terminated ends and labeled lengths let you focus on routing and connection rather than cutting, crimping, and insulating each conductor.

• Pre-crimped lugs cut crimping steps and ensure uniform terminations
• Factory-supplied heat shrink reduces manual insulation work
• Complete accessory set avoids multiple trips to parts stores
• Standard cable lengths address most common vehicle layouts

Who this kit is for: installers and DIYers building medium- to high-power car audio systems who want a ready-made wiring solution that balances performance and value. If you need an all-in-one package with oversized power conductors, interference-resistant RCAs, and on-board protection and hardware for professional-looking results, this Sky High Car Audio kit covers those needs without sourcing each component separately.