Pyle In-Wall Bluetooth Audio Receiver 100W PWA15BT

The Pyle PWA15BT is a mountable in-wall Bluetooth receiver with a built-in 100W amplifier that controls two speakers, offers mic paging, and includes USB and aux inputs for easy, discreet whole-room audio.

Replace a standard wall plate with a compact, powered audio controller that converts any room into a simple sound zone. The PWA15BT fits a universal gang-box and combines Bluetooth streaming, a 1/4" microphone input, a 3.5mm aux jack, and speaker terminal outputs into one slim wall-mounted unit. It’s designed for home, office, small retail, or classroom use where centralized, accessible audio control is preferred without bulky receivers or exposed amplifiers.

How do I stream music to the Pyle in-wall receiver?

Pair any Bluetooth-enabled device to the PWA15BT using the network name BT-RY—no password needed. Once paired, audio plays through connected speakers with a wireless range of about 30 feet (10 meters).

• Built-in Bluetooth for phone, tablet, laptop streaming
• Pairing name: "BT-RY" (no PIN required)
• 30 ft (10 m) typical wireless range
• Input selector to switch between Bluetooth, aux, and mic

What connections and controls are available on this wall plate?

The PWA15BT provides practical physical inputs and a straightforward control layout: a rotary master volume, a 1/4" mic jack for paging or announcements, a 3.5mm aux input for wired sources, a USB port for device charging, and a speaker terminal block to run two speakers. An LED indicator and power switch make status and on/off control obvious at a glance.

• Rotary master volume knob for smooth level adjustment
• 1/4" microphone jack (mic works in microphone mode only)
• 3.5mm aux input for direct audio connections
• USB port provides device charging while in use

How powerful is the amplifier and what speaker setup does it support?

This wall-mounted unit houses a Class-T stereo amplifier with a peak power rating of 100 watts and 40 watts RMS, suitable for driving a pair of standard 4–8 ohm speakers. The rear terminal block accepts hard-wired speaker connections for a clean, secure installation in typical small-to-medium rooms.

• 100W peak / 40W RMS total output
• Recommended speaker load: 4 ohm minimum
• Low distortion: 0.06% THD (8 ohm, 1 kHz)
• Speaker terminal block for dependable wiring to two speakers

What power and safety features should I know about?

The unit accepts AC 100–240V and uses an included adapter to supply the internal 12V DC electronics; an optional hard-wire method is supported for permanent installs. Built-in circuit and overload protection help prevent damage from electrical faults during normal use.

• AC 100–240V input with included adapter (12V DC output)
• Power draw approximately 2 amps under typical operation
• Integrated circuit and overload protection for safe operation
• Complies with standard gang-box wall-plate dimensions for clean mounting

Who this is for: The Pyle PWA15BT is ideal for homeowners, office managers, retail store operators, and light commercial installers who want a discreet, wall-mounted audio control solution. Choose this if you need simple Bluetooth streaming, paging capability with a mic input, and a compact in-wall amplifier that powers two speakers without an external receiver. If you plan to run multiple zones or require very high SPL in large venues, consider a multi-zone controller or higher-power amplifier instead.