MOOKEERF RG58 CB Coax Cable 150FT PL259 UHF Male

MOOKEERF 150FT CB coax cable (RG58) is a low-loss, flexible UHF male-to-male lead built for reliable antenna and radio connections over long runs.

This 150-foot RG58 coaxial cable from MOOKEERF pairs PL259/UHF male connectors with a solid-copper center conductor and a tinned-copper braid to minimize signal attenuation across CB, ham, VHF and test equipment setups. Engineered to reduce interference and resist corrosion, it includes heat-shrink, adhesive-lined tubing at each connector to lock the joint and help seal out moisture. Use it for fixed station installs, mobile rigs that need extended coax runs, or laboratory checks with SWR meters and antenna analyzers.

How much signal loss can I expect with this 150ft RG58 cable?

The MOOKEERF cable is designed for low insertion loss: measured at 450 MHz, the loss is about 0.66 dB with an SWR ≤ 1.15 under proper termination. That performance keeps most practical CB and amateur radio setups operating efficiently across that run length.

• Loss at 450 MHz: ~0.66 dB
• Typical SWR performance: ≤ 1.15 when properly terminated
• Solid copper center for stable conductivity
• Tinned copper braid for improved shielding and reduced corrosion

Will the connectors hold up and resist moisture over time?

Each end is fitted with a high-quality PL259/UHF male connector plated in copper-nickel to resist oxidation and mechanical wear. The cable-to-connector junction is reinforced with a 2.2" adhesive-lined heat-shrink sleeve to create a durable, water-resistant seal that helps prevent connector pull-out and corrosion.

• Copper-nickel plated connector shells for corrosion resistance
• Adhesive-lined heat shrink at both ends for waterproofing
• Strain-resistant assembly reduces risk of pull-apart during handling
• Suitable for outdoor or marine-adjacent installations with basic protection

Is this cable flexible enough for routing during installation?

The RG58 construction balances shielding and flexibility, making the 150ft length manageable for routing through vehicle trunks, tight conduit runs, or around antenna mounts. The jacket is pliable for bending while still providing dependable shielding performance.

• Flexible jacket for easier routing and cable management
• Lightweight enough for long runs without excessive sagging
• Works well with clamps, ties, and common mounting hardware
• Inner structure resists kinking while preserving electrical properties

Which radios and devices are compatible with this coaxial cable?

MOOKEERF’s RG58 with PL259/UHF male ends is a versatile jumper suitable for CB radios, many amateur (ham) and marine VHF systems, SWR meters, antenna analyzers, and surge protectors that accept UHF male connectors. Check your radio’s connector type and frequency needs before purchase.

• Commonly used with CB and many ham radio transceivers
• Compatible with antenna analyzers and SWR meters using PL259
• Works with marine VHF equipment if connector and frequency match
• Useful as a test lead for walkie-talkie base stations and lab setups

Who is this for? Installers, hobbyists, and small-station radio operators who need a long, dependable coax run will benefit from the MOOKEERF 150FT RG58 PL259 cable. It’s aimed at users who want lower-than-expected loss across moderate frequencies, robust connector sealing for outdoor or semi-exposed environments, and a flexible jacket that simplifies routing. If you need a longer run than typical patch leads without stepping up to heavy foam-dielectric or hardline coax, this cable provides a practical balance of performance, durability, and value for CB and amateur radio applications.