MOOKEERF RG11 50ft Low-Loss Coax Cable 14AWG

MOOKEERF RG11 50ft coaxial cable is a heavy-duty, low-loss 75Ω cable with a 14 AWG center conductor and F-type connectors designed for long runs to deliver clearer TV, satellite, and antenna signals.

This 50-foot RG11 cable from MOOKEERF pairs a thicker 14 AWG conductor with dual shielding (100% foil + 60% braid) and weather-resistant jacketing to preserve signal quality across extended distances. It’s built for indoor and outdoor installations where minimizing attenuation matters — for rooftop satellite feeds, long cable runs to DVRs, or antenna connections in mobile and fixed setups.

How does this RG11 cable reduce signal loss on long runs?

RG11 has a larger conductor and different electrical characteristics than RG6, which lowers attenuation across higher frequencies and long distances. The MOOKEERF model combines that physical advantage with higher shielding coverage to reduce interference and maintain consistent levels.

• 14 AWG solid center conductor for improved current handling and lower resistance
• Dual shielding: 100% aluminum foil plus 60% braid for EMI/RFI protection
• 75 ohm impedance matched for CATV, satellite and antenna systems
• Optimized for long runs where RG6 would show noticeable loss

Will the connectors and jacket survive outdoor installations?

Yes — the cable comes with factory-mounted F-type connectors made to resist pulling and signal loss, and the PVC jacket is UV resistant for outdoor exposure. That combination keeps the connection stable through temperature swings and typical weather conditions.

• Pre-installed, high-quality F-type connectors reduce installation errors
• UV-resistant PVC jacket for sunlight and outdoor durability
• Connector crimps and strain relief designed to prevent separation
• Suitable for rooftop, mast, and wall-fed cable routing

What devices and systems is this cable compatible with?

This 75Ω RG11 cable is intended for devices and systems requiring low-loss coaxial connections: satellite dishes, CATV distribution, VHF/UHF antennas, DVRs, and radio equipment. It works where a thicker cable is needed to preserve signal integrity over distance.

• Satellite dish and LNB connections for better long-run performance
• CATV and cable TV distribution lines to amplifiers and set-top boxes
• Antenna runs for VHF/UHF and over-the-air TV reception
• Radio and amplifier interconnects in commercial or residential installations

How easy is it to install and what should I watch for?

Installation is straightforward for anyone familiar with coax: the cable arrives with F-type connectors pre-attached, so you typically only need to route and tighten. Keep bends gradual, avoid sharp kinks, and use correct mounting hardware to prevent strain on connectors.

• Use a proper wrench to snug F-connectors; avoid overtightening
• Maintain gentle bend radius to prevent conductor or dielectric damage
• Secure cable with UV-rated clips or conduit for long outdoor runs
• Consider splitters and amplifiers rated for RG11 runs to preserve performance

Who this cable is for: installers, hobbyists, and homeowners who need a robust 50-foot coax for long-distance TV, satellite, or antenna hookups. Choose MOOKEERF RG11 50ft when you require lower attenuation than RG6, solid shielding against interference, and weather-ready construction for outdoor feeds.