MOOKEERF PL259 100ft RG58 UHF Coax Cable

MOOKEERF PL259 100ft UHF coax cable is a low-loss, weather-resistant RG58 jumper with a PL-259 (UHF) male termination designed for CB, ham radio, VHF/antenna analyzers and SWR meters.

If you need a long, reliable connection between radios, antennas or test gear, this 100-foot MOOKEERF cable gives you a performance-focused link that minimizes signal attenuation and resists corrosion. Built with a solid copper center conductor, bonded foil plus tinned-copper braid, and nickel-plated PL-259 hardware, it balances flexibility and durability for permanent installs or portable setups.

How much signal loss will I see over 100 feet?

The MOOKEERF PL259 RG58 cable is built to keep loss low across common radio bands. At 450 MHz the measured loss is about 5.9 dB, and the cable supports low SWR values when properly matched, helping preserve transmit and receive performance over a 100-foot run.

• Measured attenuation: ~5.9 dB at 450 MHz
• SWR performance: typically low when antenna system is matched
• Construction that reduces dielectric and shielding loss

Is this cable durable enough for outdoor or mobile use?

Yes — the assembly uses corrosion resistant materials and protective sealing to withstand weather and handling. The PL-259 shells are copper with a nickel finish for oxidation resistance, and a heat-shrink sleeve with adhesive seals the connector-to-cable junction to resist moisture and strain.

• Nickel-plated PL-259 shell for corrosion protection
• Adhesive-lined heat-shrink at the joint to block water intrusion
• Flexible RG58 jacket for routing in tight or moving installations

Will this cable fit my CB, ham rig, or SWR meter?

The cable terminates in a standard PL-259 (UHF male) which mates with SO-239 sockets found on many CB radios, amateur transceivers, antenna analyzers, and SWR meters. It’s widely compatible with VHF/UHF equipment that uses UHF-style connectors, but verify connector type on your specific gear before ordering.

• PL-259 (UHF) male termination fits SO-239 receptacles
• Commonly used with CB, ham, marine VHF, analyzers, and meters
• Adapter-friendly for systems needing alternate connector types

How is the cable constructed to reduce interference and connector failures?

MOOKEERF combines a solid copper center conductor with a bonded aluminum foil shield and dense tinned-copper braid to provide consistent impedance and reliable shielding. The strain-relief heat shrink plus quality metal plating prevent connector pull-out and reduce the chance of intermittent contact or RF noise at the junction.

• Solid copper inner conductor for stable electrical contact
• Foil plus tinned-copper braid for effective shielding
• Adhesive-lined heat shrink reduces connector separation and moisture ingress

Who is this for? Installers, hobbyist radio operators, mariners, and field technicians who need a long, dependable RF link will find this MOOKEERF 100ft PL259 RG58 cable useful. It’s suited for permanent outdoor runs, mobile setups, test bench connections to SWR meters or antenna analyzers, and any application that requires a standard PL-259/UHF male termination with weather-resistant protection and predictable RF performance.